OVCam Drivers for 2.4 and 2.6 kernels

More thorough installation instructions are available at:
http://ovcam.org/ov511/install.html

Simplified Installation Instructions:

  IMPORTANT NOTE FOR 2.6 KERNELS:
  The OVCam drivers use the new 2.6 modular build process. You must have
  read/write access to your kernel source tree. If not, log in as root before
  running the following commands.

	make clean
	make
	(log in as root)
	make install

Loading the modules:

  As of version 2.21, the camera chip code is in a separate module (ovcamchip).
  If you have a camera, this must be loaded either before or after loading the
  ov511 or ovfx2 drivers:

	modprobe ovcamchip

  or, if you have a video-capture box from Lifeview (USB CapView):

	modprobe saa7111-new

  If the box also has a TV tuner (Lifeview USB LifeTV):

	modprobe tda7313	(audio chip driver)
	insmod tuner.o		(TV tuner driver. This is different from the
				 tuner.o that's in the kernel)

  Finally, load the driver itself. For OV511, OV511+, OV518, and OV518+ cameras:

	modprobe ov511

  or, for the Orange Micro iBot2:

	modprobe ovfx2

Compression support:

 - For OV511/OV511+ cameras: Compression support is built into ov511.o. You
   must load ov511.o with the "compress=1" module parameter to enable it.

 - For OV518/OV518+ cameras: Compression support is built into ov511.o and
   enabled by default.

 - For OVFX2 cameras: Compression is not supported by the camera (USB 2 is fast
   enough to not need it).

Please see ov511.txt for more information.
